After the first two keys are programmed, additional keys can be entered individually by following the instructions for adding duplicate keys (below). Two new keys should be ready because the system requires a minimum of two keys in the program. There are two ten minute delays involved while this device erases all existing key programming and sets up the vehicle computer to accept new key codes.
It has replaced ALL the previous electronic key codes and is the ONLY key programmed into the vehicles computer.ġ.Insert an existing key into the ignition cylinder.Ģ.Turn the ignition cylinder to ON(RUN) and back to OFF.ģ.Remove the existing key and, within 15 seconds,insert the new key and turn it to ON(RUN).Ĥ.The security light will light up for two seconds to indicate success in programming the key into the vehicle.ĥ.Don’t attempt to start the vehicle with any key for at least 1 minute.įor Ford keys (Later 1998-newer Ford, Lincoln, Mercury) The dash will flash for fifteen more minutes.Ĥ.After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car. Turn the ignition cylinder to OFF and then back ON (RUN) position. The security light on the dash will flash for fifteen more minutes.ģ.When the security light stops flashing, you have FIVE minutes to start the next step. Turn the ignition cylinder OFF and then back to the ON (RUN) position. The security light on the dash will flash for fifteen minutes.Ģ.When the security light stops flashing, you have FIVE minutes to start the next step.
If you want to initiate a new master key….ġ.Insert new key into ignition cylinder and turn it to the ON (RUN) position. Ease cannot confirm that these procedures work for every year and model listed.įor Ford keys (1996 -early 1998 Ford, Lincoln, Mercury) NOTE: These instructions may apply to more or less vehicles than those listed above. This PAT programming apply to below models:
0 kommentar(er)
